Stringer Codes with Comments
Posted by Jason Coghlan on 26 November 2013 11:36 AM
From our Developer he has given us an insight into Power Poles and comments after the code. If you read below and do this on your jigger for the code you will be able to get the same results.

With power poles joined, I cheat. My coding will be “PP PZ 55”. PP Being my symbol and PL being the power line. This allows me to have PL’s that go to PPL (Power Pole with Light = PPL PZ 55) or in to a building. After I do the Split all codes I do a global replace of “PZ “ to “PL”: i.e. remove the space after all PZ’s, so PP PZ 55 becomes PP PL55, etc. I use PZ because I never use PZ for anything else.

One of the primary problems is that it's is not finishing the codes with a space. 
For example, the code needs to be BLD30 –BUS SHELTER with a space after the BLD30.
Same with the trees.
I did a global replace and replaced “-“ with “ –“. Fixed it all.

Have a try and see how you with this.
(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako