Knowledgebase: Civil Site Design (prev. Advanced Road Design)
I Can't See Parallel Pipes in the Pipe VGE or Long Sections
Posted by Shane O'Rorke on 25 October 2011 10:27 AM
|
|
The display of offset/parallel pipes in the Pipes VGE or on a pipe long section is controlled in the Active Network Settings. From the Ribbon, click on the Pipes Tab, and then Active Network Settings from the Settings panel. Only pipes that are part of a pipe network will be displayed. On the General > Defaults tab, increase the 'Maximum Distance to Check for Pipe Clashes'. This will enable ARD to display pipe networks at a greater offset from the selected pipe network. Version: ARD 2011 and later | |
|
Comments (0)