Knowledgebase
Hidden Forms (not displaying on your monitor)
Posted by Jason Coghlan on 02 September 2021 08:37 AM
|
|
A form opens but I can't see it - why? After you open a form with Civil Site Design or Stringer Topo, reposition and then close it, the software 'remembers' the form position. When you next run the same command, the form will open up in the last saved position. If you open a drawing that another designer has used (with a different monitor configuration) or you disconnect/rearrange your monitors, it could be that the form will display in a position where a monitor isn't attached (so you don't see the form). So, how do I fix it? When a form does open, even if you can't see it on screen, you will find a miniature of it when you hover over the Windows taskbar at the bottom of the screen and hover over your CAD application. You can normally restore the form onto your main monitor by:
Once the form is moved and closed, it should remember this new position when you reopen. It is possible that the above method isn't available or doesn't work. If that is the case please do the following:
| |
|
Comments (0)