ARD Pipes - Set Branch Line Longsection Chainages to start at 0.00m
Posted by Grant Lyons on 11 May 2012 03:31 PM

If you have drainage longsections where the branch line chainages start at the chainage of the manhole along the main line that it connects into

and you want the branch line to start with chainage 0.00m then follow this procedure.

1. Enter the plot pipe long section dialog box

2. Edit the Data Bands/Controls

3. Highlight the DrainSettings line (if it does not exist then add in General Settings item)

4. Click on Edit Current Line

5. Place tick in the box next to Start Line Chainage from Zero.

(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako