"Run-time error 9" When Resample Cross Sections
Posted by Andrew Banson on 23 February 2010 02:44 PM

"Run-time error 9" When Resample Cross Sections

Q. I have just designed a road and vertical grade etc. The software was working fine and then i changed the alignment length slightly and then tried to regenerate cross sections to view new cross sections. Now I go into edit and try and resample cross sections and get Run-time error 9 saying subscript out of range.

A. It seems as if your Alignment extends beyond the sampled surface. Your Alignment must always been contained within the sampled surface.


1) Increase the size of the sampled surface

2) Resize the Alignment so that it is contained within the Surface

ARD 2010.02

(110 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako