Model Viewer - Design Surface does not trim to the Base Surface #
Posted by Shane O'Rorke, Last modified by Selwyn Pendergast on 13 March 2020 09:44 AM

You have created a design on your base surface, and when you show it in Model Viewer the trimming isn't applied or is only partially applied.

There are a few possible causes for this:

  • Surface discontinuity - the trimming algorithm is expecting a single 'outer' boundary for the surface.  If your surface is not contiguous (there are multiple areas of triangulation with gaps between) the software will try to form a single boundary around all the triangles
  • The Base Surface has been simplified - this can cause large triangles next to very small/sliver triangles on the design surface, which the software algorithm may fail to detect as a border
  • The Base Surface has been set to 'fast draw' or cached - in these cases the boundary is either not applied or not updated following edits in the design

(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako support.civilsurveysolutions.com.au/index.php?