Getting Points showing in the object viewer #
Posted by Jason Coghlan on 13 March 2020 03:26 PM
You need to go and change your point style in the settings tab
Settings Tab>Point>Point Styles>Standard
Right click on the Standard Point Style>Edit.
Then go to the Display Tab at the top, Under View Direction change that from Plan to Model and make sure you tick the light bulbs so you can see them. Click OK
Then go and select one of the standard point styles in the drawing and the 3d polyline from stringer, right click select similar and then right click again Object Viewer. When the object viewer opens you will see both the linework and the points in the viewer
(3 votes)
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako